Portside Dopp Kit: Zipper Pulls
This is an optional step but I think it makes the set look a bit more polished and the leather pulls are easier to grab than the metal pulls. Begin by tracing your pull tab piece out onto your leather scrap. I traced mine with a white gel pen, but a sharpie will also work if you're using a lighter colored leather.
Cut two pulls and trim any jagged edges that may have occurred while cutting.
On the pattern piece you'll see a short line on one end of the pull that says "Cut Slit Here," you'll need to cut that line open on your leather pieces so that you can attach the pull.
Using an exacto knife, cut from the edges to the center to ensure that you don't accidentally cut through the edge! You can see my slit above.
Now thread one end of the leather pull through the hole in your zipper pull as shown above.
Feed the rear end of the pull through the slit you cut in the other end.
Pull the end through the slit until the leather pull is flat.
Repeat this step for the other zipper and your bag is complete and ready to keep or gift!